Runs but never cools
The compressor you can hear is still working. The thermostat, fan or defrost heater has failed.
Sensors measured against real cabinet temperatureA fridge that stops cooling costs you the shelves by morning. We diagnose it at your home today and quote before anything is replaced.
Fault not listed? Describe it on the booking form and our coordinator will match the right engineer.
Knowing which one you have is what keeps the diagnosis short and the bill honest.
The compressor you can hear is still working. The thermostat, fan or defrost heater has failed.
Sensors measured against real cabinet temperatureThe defrost heater has stopped clearing the evaporator, so frost blocks the air to the fridge.
Defrost heater, timer and cut-out testedThe defrost drain has blocked, so meltwater backs up into the cabinet.
Drain cleared, drip tray checked. Short jobThe three things households complain about in this trade, dealt with before the engineer opens anything.
You hear one figure covering parts and labour. It does not move once you approve it, and a second fault gets priced separately.
We fit parts from approved suppliers and write the number on your sheet, so you can check it against the maker's catalogue.
Every finished job carries a warranty period on our labour and the part supplied, printed on the sheet we hand over.
Have the model number from the rating plate ready, plus any code on the display. That decides which parts go into the van.
Brand, model and the fault. We confirm a slot that suits your day.
Panels off, components measured. Nothing is replaced on a guess.
One figure for parts and labour. Work starts only when you say yes.
A full cycle runs while you watch, and you keep the service sheet.
A fridge rejects its heat into the room, and in August that room is already warm. The compressor runs longer cycles for months. A condenser coil furred with dust cannot shed that heat at all, which is why coil cleaning matters more here.
What UAE conditions do to appliancesHouseholds who booked this repair and told us how the visit went.
Fix My Appliance is an independent repair company and is not an authorised agent for any manufacturer.
Send the model number and a photograph of anything on the display. There is no charge for the answer.
Sealed system work needs recovery equipment and scales, so it goes to our bench. Many fridges run on R600a, which is flammable, so it is not a quick top up job anywhere.
Leave it closed. Keep the door shut and a full fridge holds about four hours, while a full freezer holds roughly a day. Opening it to check is what spends that margin.
Rarely past the design life. It is the most expensive part and the least often at fault, so we test the start relay, the overload protector and the fans first.
Probably not. Inverter compressors run continuously at low speed instead of switching on and off. What matters is whether it holds temperature.
At home, apart from sealed system work. The gas circuit needs bench equipment, and we tell you before anything leaves your kitchen.
Repair, installation and maintenance run through the same coordinator and the same service record.