No heat
Lint packs the filter, condenser and duct. Airflow drops and the thermal cut-out trips to protect the machine.
Lint cleared, then element and cut-out testedDamp clothes after a full cycle means lost heat, not a lost motor. Lint is usually the cause, so we clear that as well as fitting the part.
Fault not listed? Describe it on the booking form and our coordinator will match the right engineer.
Knowing which one you have is what keeps the diagnosis short and the bill honest.
Lint packs the filter, condenser and duct. Airflow drops and the thermal cut-out trips to protect the machine.
Lint cleared, then element and cut-out testedA squeal rising with the drum is the belt or idler pulley. A rhythmic thump is the support rollers.
Belt, pulley and rollers replaced as a setA condenser model has stopped emptying itself through a blocked block, pump or stuck float.
Condenser block and pump cleared and testedThe three things households complain about in this trade, dealt with before the engineer opens anything.
You hear one figure covering parts and labour. It does not move once you approve it, and a second fault gets priced separately.
We fit parts from approved suppliers and write the number on your sheet, so you can check it against the maker's catalogue.
Every finished job carries a warranty period on our labour and the part supplied, printed on the sheet we hand over.
Have the model number from the rating plate ready, plus any code on the display. That decides which parts go into the van.
Brand, model and the fault. We confirm a slot that suits your day.
Panels off, components measured. Nothing is replaced on a guess.
One figure for parts and labour. Work starts only when you say yes.
A full cycle runs while you watch, and you keep the service sheet.
Laundry rooms here are small, enclosed and warm. A vented dryer with a long or sagging duct, or one ending inside a closed room, breathes its own exhaust. Drying times stretch, the cut-out trips, and the element goes next.
What UAE conditions do to appliancesHouseholds who booked this repair and told us how the visit went.
Fix My Appliance is an independent repair company and is not an authorised agent for any manufacturer.
Send the model number and a photograph of anything on the display. There is no charge for the answer.
Heat pump dryers carry a sealed refrigerant circuit like a fridge. Everything outside it we repair at your home, but the sealed side needs bench equipment and on some models the part is not sold separately at all.
Airflow. Start with the lint filter and condenser block, then the duct run. A machine that cannot move air cannot carry moisture out.
Every load, and the condenser block monthly. It takes under a minute and prevents the overheating that kills elements.
A thermal cut-out opening on heat and resetting as it cools. The cut-out is working, so the question is why it is overheating.
Condenser or heat pump, in most cases. A vented model needs a short straight duct to outside air, and most apartments cannot give it one.
Repair, installation and maintenance run through the same coordinator and the same service record.